Once inside the desired Assembly, click "Welds" and select the Weld you want to add the instructions to...

Once inside the desired Assembly, click "Welds"

Scroll down and you'll find the "Groove Design" and "Weld Layer Configuration"

Clicking on "Actions", you'll find options to Select, Copy from WPS or even Create a New Sketch, just like you can do in WeldCloud Notes.\
You can even Customize your designs if needed.

If you want, you can even create a new sketch by clicking "Actions" and then "Create New Sketch".\
This will take you to WeldCloud Notes to continue.\
After you're done, go back to your Weld in Assembly, and add your new design.

If you want, you can even create a new sketch by clicking "Actions" and then "Create New Sketch".\
This will take you to WeldCloud Notes to continue.

Create your Base Design

Introduce the base plates of your joint. These won't be adjustable for each WPS or PQR.

You can do the same for the "Weld Layer Configuration" as you did for the "Groove Design"

Create Weld Instructions in WeldCloud Assembly