[[Right click]] on the benchtop you wish to add the breakfast bar too.

click the edge you would like to extend out

[[Right click]] the anywhere in the black background

Enter the value in mm you intent to extend the bench, click [[OK]] to confirm 

Waterfall benchtop starts from this point.

Click [[Edit]] under the countertop section 

Select the edge you want to apply the waterfall to. *This is indicated by the red line*

Tip! There are multiple styles available from the style tab. This example uses Style4.

- Thickness(t) refers to the thickness of the vertical part of the benchtop
- Real thickness is not used for this style
- Width(w) refers the amount extending out from the original benchtop
  - This needs to be enough to allow for the thickness of the vertical section.
  - If you used the automatic countertop tool and you had set in your style setting under worktop to have a Side edge overhang then this many need to be allowed for in the Width(w)
- Check Box for "On Floor" can be toggled on and off depending if you intend to not extend down to the floor.

Kdmax

This guide provides step-by-step instructions on how to add a breakfast bar and waterfall end to a benchtop using KD Max software.

KD Max - Add a breakfast bar and waterfall end to a benchtop