Connect a Rover in Trimble Siteworks
Sitech Northeast
22 steps
2 minutes
Siteworks (PC Edition)
1
Tap on the top left menu.
2
Tap on "Project Setup".
3
Tap on "Connect Device".
4
Tap on "GNSS".
5
Tap on the "Mode" drop box.
6
Tap "Rover".
7
Tap on the "Connection type" drop box.
8
Select "Bluetooth".
9
Tap on the Bluetooth logo next to the Bluetooth device field to start a Bluetooth scan/search.
10
Wait for your rover's serial number to appear in the Bluetooth device list and then tap on it.
Your receiver's serial number can be found on the bottom of the unit above the bar code.
11
Tap on "OK" with the Bluetooth device selected.
12
Tap on the "Correction method" drop box. This is how the rover will communicate with the base.
13
Tap "Radio in Receiver".
14
Tap on the 'Radio Mode" drop box.
15
Tap on "900".
16
Tap on the "Network ID" drop box. This is the radio channel in which the Base and Rover will communicate on. You can select any channel 1-40, but both the base and rover must be on the same channel.
17
Tap the same "Network ID" your base is on.
18
Tap on the "Using Quick Release" drop box.
19
Select "No".
20
Tap on the "Enable Tilt Compensation" drop box.
21
Tap "Yes".
22
Ensure your "Antenna height" is set to 6.562usft or 2m and then tap "Accept" to finish your rover setup.
If your rover's antenna height is 6.562usft or 2m. You can type 2m as your antenna height and Siteworks will make the conversion to usft.
Connect a Rover in Trimble Siteworks
Sitech Northeast
22 steps
2 minutes
Siteworks (PC Edition)
1
Tap on the top left menu.
2
Tap on "Project Setup".
3
Tap on "Connect Device".
4
Tap on "GNSS".
5
Tap on the "Mode" drop box.
6
Tap "Rover".
7
Tap on the "Connection type" drop box.
8
Select "Bluetooth".
9
Tap on the Bluetooth logo next to the Bluetooth device field to start a Bluetooth scan/search.
10
Wait for your rover's serial number to appear in the Bluetooth device list and then tap on it.
Your receiver's serial number can be found on the bottom of the unit above the bar code.
11
Tap on "OK" with the Bluetooth device selected.
12
Tap on the "Correction method" drop box. This is how the rover will communicate with the base.
13
Tap "Radio in Receiver".
14
Tap on the 'Radio Mode" drop box.
15
Tap on "900".
16
Tap on the "Network ID" drop box. This is the radio channel in which the Base and Rover will communicate on. You can select any channel 1-40, but both the base and rover must be on the same channel.
17
Tap the same "Network ID" your base is on.
18
Tap on the "Using Quick Release" drop box.
19
Select "No".
20
Tap on the "Enable Tilt Compensation" drop box.
21
Tap "Yes".
22
Ensure your "Antenna height" is set to 6.562usft or 2m and then tap "Accept" to finish your rover setup.
If your rover's antenna height is 6.562usft or 2m. You can type 2m as your antenna height and Siteworks will make the conversion to usft.
