Importing Points into Siteworks
Sitech Northeast
12 steps
33 seconds
In order to import a point file into Siteworks, it must be in .csv format using PNEZD coordinate order.
1
Load into the job and design you would like to import points to in Siteworks. Then tap on **ACCEPT**.
2
Complete your reciever setup or close out of it.
3
Tap on the top left menu.
4
Swipe down and tap on **Data Management**.
5
Tap on **Point Manager**.
6
Tap on **Import Point File**.
7
If importing as built points switch the first dropdown from Control Points to **Stakeout Points**.
Plug in your USB flash drive with the point file you would like to import to Siteworks in your data collector now.
8
Tap on **Stakeout Points.** Then tap **"Tap to select file"**.
9
Switch from your C: drive to your **D: drive** to view files on your flash drive.
If you have an SD card installed in your collector, the USB will display as (E:).
10
Find your point file, tap on it once to highlight it orange.
11
Tap **ACCEPT.**
12
The name of your point file should appear next to File Name, tap **ACCEPT** again.
If you imported a Stakeout Point file, the points would display as an "x" in Siteworks' 2D view. If you imported a Control Point file, the points would display as a triangle in Siteworks' 2D view.
Importing Points into Siteworks
Sitech Northeast
12 steps
33 seconds
In order to import a point file into Siteworks, it must be in .csv format using PNEZD coordinate order.
1
Load into the job and design you would like to import points to in Siteworks. Then tap on **ACCEPT**.
2
Complete your reciever setup or close out of it.
3
Tap on the top left menu.
4
Swipe down and tap on **Data Management**.
5
Tap on **Point Manager**.
6
Tap on **Import Point File**.
7
If importing as built points switch the first dropdown from Control Points to **Stakeout Points**.
Plug in your USB flash drive with the point file you would like to import to Siteworks in your data collector now.
8
Tap on **Stakeout Points.** Then tap **"Tap to select file"**.
9
Switch from your C: drive to your **D: drive** to view files on your flash drive.
If you have an SD card installed in your collector, the USB will display as (E:).
10
Find your point file, tap on it once to highlight it orange.
11
Tap **ACCEPT.**
12
The name of your point file should appear next to File Name, tap **ACCEPT** again.
If you imported a Stakeout Point file, the points would display as an "x" in Siteworks' 2D view. If you imported a Control Point file, the points would display as a triangle in Siteworks' 2D view.
