Is my Logix Tracker uploading correctly? | Scribe

Is my Logix Tracker uploading correctly?

  • 7 months ago
  • RapidlogixRapidlogix

By following these steps, you can effectively check and that your Rapid Logix Tracker is uploading correctly.

Step 1: Verify Power and Connectivity

Confirm Connectivity:

Make sure the tracker is within an area that has 4G coverage. (This can be confirmed by using a mobile phone to check the strength)

Confirm Power:

Make sure the charge cable is providing at least 5 volts of output and both the connector & magnetic port on the device is clean and free of foreign material or corrosion.

  • Use CRC5.56 or similar with a nylon brush to clean surfaces.

Step 2: Monitor Data Upload Status

Confirm Status:

Confirm the following sequence is occurring.

Step 3: Access the Rapid Logix Portal

Log In:

Access the web application for your Rapid Logix Tracker.

Confirm Logs:

Using the calendar in the Job view, navigate to the month/day that you recorded a spray log.


Troubleshooting Common Issues

No Recent Uploads in the portal:

  • Power down and restart the tracker to reset the device connection.

  • Check the strength of the 4G coverage with a mobile phone and move to an area with a stronger signal if its poor.

  • Confirm the status lights perform the correct sequence in Step 2 above.

Erroneous Data: Do not 'Complete' the Job before going through these steps!

  • If the data seems incorrect or incomplete:

    • Check the correct device has been selected for the Job & update if necessary.

    • Check that the data hasn't been included in a different job around the same timeframe.

    • Check the Unassigned log for any left over data points, if extra data is found simply edit the start or end time to include the log/s.

    • Go through steps 1-3 above to reinitiate a 4G data upload.

  • GPS logs successfully but without any heat map data present:

    • Check auto shut off period on the device is sufficient for the travel time between spraying, the device may be shutting down before spraying begins.

      • Increase Sleep timeout in 30 minute blocks until a time is effective (we recommend a minimum of 60 minutes)

    • Check & confirm the turbine in the device is able to spin freely by removing the device from the delivery hose and blow through the device with air and flush with clean water before the device is used again.

  • No Data available in the job:

    • Check the correct device has been selected for the Job & update if necessary.

    • Go through steps 1-3 above to reinitiate a 4G data upload.

    • Check & confirm the turbine in the device is able to spin freely by removing the device from the delivery hose and blow through the device with air and flush with clean water before the device is used again.

Step 5: Contact Support

If the above steps do not resolve the issue, Reach out to the customer support team for assistance via the following pathways.

Call Support: 1300 901 504

Email Support: [email protected]

Provide them with details of your troubleshooting efforts for more effective help.