How to add a bull nose cutout for a shower bench
- 13 steps
Add a corner notch
1
**Right-click** on a panel to add a corner notch
2
Navigate from **"Layout"** to **"Set Notches"**
Select a **Location** for the notch
3
Select how many steps you require on the notch - i.e. single, double or triple.
4
Enter your dimensions accordingly.
**Hint:** You can do this via the Measurement Grid tab, or click on a letter on the diagram to enter the dimension for that edge.
Add a rectangular notch cutout
5
Click **"Cutouts"**
6
Click **"Add Cutout"**
7
Click **"Rectangular Notch"**
8
Select the relevant panel (whichever panel you added the corner notch to)
9
Select a Panel **"Edge"** to apply the rectangular notch to that edge.
This would typically be **"<Left/Right> Notch Vertical"**.
10
- Select **"Top"** in the "From end of glass edge" field
- Enter the ''Offset to cutout centre"
***Hint:*** *Since cutout offsets are measured to the cutout centre, and the cutout is placed on the top of the corner notch vertical edge, you can calculate the offset by dividing the height of your required rectangular notch by two.*
11
Enter a value into the **"Notch Inwards"** field - this should be the width of the notch, or how far in from the edge it goes.
12
Enter a value in the **"Notch Along"** field - this should be the height of the notch, or how long along the edge it goes.
13
The glass drawing will now show the rectangular cutout on the corner notch.
