How to apply radius or angled corners in the Glass Designer (Metric)
16 steps
Smartglazier
1
From the Glass Designer screen, enter your measurements and select your glass details, then click on **"Add Cutout"**.
2
Click **"+ Corner"** to add a new corner process
How to apply radius corners
3
Select **"Radius Corner''**
Enter a value into the **"Radius"** field.
4
Tick the checkboxes to select which corners this radius corner process should be applied to.
Or, tick **"Select All"**
5
Click **"Apply Corners"**
6
Click **"Continue"**, then **"Ok"** after reading the pop-up messages.
7
The diagram will now display the radius corners.
You can click directly on a radius corner on the diagram to change the radius value of that corner.
NOTE: The glass designer does not currently support drawing arches. The closest workaround we have is to draw half-rounds by entering two radius corners on the top left and right corners.
How to apply angled corners
8
Click **"+ Corner"**
9
Click **"Angled Corner"**
10
Enter values in the **"Horizontal Size"** and **"Vertical Size"** fields
11
Tick the checkboxes to apply the angled corner to specific corners, or tick **"Select All".**
Then click **"+ Apply Corner".**
12
You will now see the angled corners on the glass diagram.
How to remove radius / angled corners
13
To remove radius/angled corners, navigate to the **"Glass"** tab and click **"+ Corner"**
14
Select **"Remove Existing"**
15
Click **"Select All"** or tick the checkboxes to remove the corner process from specific corners.