Micro Raw set up
Nick Luczak
17 steps
2 minutes
1
Choose network
2
Select Wired
3
choose TCP mode
4
Apply Network configuration
5
Choose the device in Trellis to inspect filter settings and more
6
Here you see all the different options for streaming data through Trellis as well as their filtering
7
Click here
8
Choose what input signal you would like to stream through BCI2000
9
For this example we choose 'Raw Signal,' although all streams are supported in BCI2000
10
Open your BCI2000 installation
11
Go to the batch folder
12
Open a batch file which runs the RippleADC as a source module
When you build your solution, you will find three "stock" BCI2000 applications appended with "\_RippleADC"
13
Click "Config"
14
Click "Source"
15
Choose a sampling rate. In this case, Raw data streams at 30,000 KHz
It's vital to know the sampling rate of the device, as different types of streams and front ends have different sampling rates
16
Click "Set Config"
17
Start your experiment!
Micro Raw set up
Nick Luczak
17 steps
2 minutes
1
Choose network
2
Select Wired
3
choose TCP mode
4
Apply Network configuration
5
Choose the device in Trellis to inspect filter settings and more
6
Here you see all the different options for streaming data through Trellis as well as their filtering
7
Click here
8
Choose what input signal you would like to stream through BCI2000
9
For this example we choose 'Raw Signal,' although all streams are supported in BCI2000
10
Open your BCI2000 installation
11
Go to the batch folder
12
Open a batch file which runs the RippleADC as a source module
When you build your solution, you will find three "stock" BCI2000 applications appended with "\_RippleADC"
13
Click "Config"
14
Click "Source"
15
Choose a sampling rate. In this case, Raw data streams at 30,000 KHz
It's vital to know the sampling rate of the device, as different types of streams and front ends have different sampling rates
16
Click "Set Config"
17
Start your experiment!
