Wideband Setup in VCM Scanner - AEM 30-0300 | Scribe

    Wideband Setup in VCM Scanner - AEM 30-0300

    • 14 steps

    Wiring Guide

    1
    After the wideband is installed in the vehicle, make the following wiring connections from the AEM to the HP Tuners ProLink connector: - AEM Red (Power) **→** Vehicle Switched +12V - AEM Black (Ground) **→** Vehicle Ground (chassis, battery, etc.) - AEM White (Analog +) **→** ProLink Red (Analog 1) - AEM Brown (Analog -) **→** ProLink Black (Ground)
    2
    Connect the ProLink to your HP Tuners interface

    Add Wideband Channel in VCM Scanner

    3
    Open the VCM Scanner application
    4
    Click the "Add Channel" button (gear with the green +)
    5
    In the channel selector, scroll down to the External Inputs section. Click the small "+" next to "MPVI2, MPVI2+, MPVI3"
    6
    Click the small "+" next to "Pro Link, Pro Link+"
    7
    Double-click "MPVI2 PL A/D Input 1 (Red)"
    8
    Click "Close" on the Channel Selector window
    9
    Find the newly added channel in the channel list, then right click on it
    10
    Click "Transform"
    11
    In the "Transform Selector" window, click the small "+" next to "Equivalence Ratio"
    alert ordinal icon
    DO NOT select the Air-Fuel ratio option. All of the custom math and tuning parameters on our end work with Equivalence Ratio.
    12
    Double-click "AEM 30-(03x0,2340,5130)"
    13
    Verify that the transform was successfully applied to the channel. It should look like this.
    14
    Your AEM wideband (30-0300) data is now ready to be recorded with the rest of the vehicle data.