Key-in Elevation while Measuring a Point

Sitech Northeast
11 steps
33 seconds

Load into the project in Siteworks.

Tap on the menu in the top left.

Tap **Settings**.

Tap on **Measure**.

Change the drop-down menu for **Measurement Offset** from Disabled to **Enabled**.

Tap **ACCEPT**.

Tap the blue plus button to measure a point.

Tap in the **Vertical offset** box to key in a vertical offset.

Notice the Vertical Offset drop down menu is set to **"V. offset"**. The V. offset feature will allow you to key-in a specific vertical offset from your rover's current elevation. When the point is measured, the horizontal data will be recorded based on the rover's position and the elevation will be recorded based on any offset applied.

Positive (+) Offset will be above your rover's current elevation. Negative (-) Offset will be below your rover's current elevation.

The Vertical Offset drop down menu can be changed to **Elevation**. The Elevation feature allows you to key-in a specific or known elevation you would like the measured point to fall at. The horizontal data will be recorded based off of the rover's position and the elevation will be saved as the entered value.

Tap **ACCEPT** to record the point.