Siteworks Plumb Pole Routine
Siteworks - Version 1.75
Sitech Northeast
10 steps
4 minutes
Ensure bubble level on the rod is reading true. Complete the e-Bubble calibration before Plumb Pole Routine (**Please see our other document on this**). Make sure tilt- compensation is on and Receiver light panel is facing you.
1
In the plan view of Siteworks tap on the picture of the **satellite** in the upper right corner that includes the number of satellites you are tracking.
2
The GNSS Status screen will appear. Tap on the **Settings** tab on the upper right half of the screen.
3
Tap on the **Plumb Pole Routine.**
4
Level your bipod range pole. Then tap **start.**
5
Siteworks will begin taking measurements. Wait for the percentage to get up to **100%** for Phase 1.
6
Siteworks will ask you to rotate your range pole **Clockwise or Counterclockwise 180 degrees.** In the circle on the right, there will be a target area to get in,
7
Tap **start** to begin the second measurement once in the target area.
8
Tap **Yes.** If the correction values are acceptable.
If **No**, perform these steps again.
9
Tap **Ok**.
10
Tap **Accept** to confirm the Plum Pole Routine is complete.
Siteworks Plumb Pole Routine
Siteworks - Version 1.75
Sitech Northeast
10 steps
4 minutes
Ensure bubble level on the rod is reading true. Complete the e-Bubble calibration before Plumb Pole Routine (**Please see our other document on this**). Make sure tilt- compensation is on and Receiver light panel is facing you.
1
In the plan view of Siteworks tap on the picture of the **satellite** in the upper right corner that includes the number of satellites you are tracking.
2
The GNSS Status screen will appear. Tap on the **Settings** tab on the upper right half of the screen.
3
Tap on the **Plumb Pole Routine.**
4
Level your bipod range pole. Then tap **start.**
5
Siteworks will begin taking measurements. Wait for the percentage to get up to **100%** for Phase 1.
6
Siteworks will ask you to rotate your range pole **Clockwise or Counterclockwise 180 degrees.** In the circle on the right, there will be a target area to get in,
7
Tap **start** to begin the second measurement once in the target area.
8
Tap **Yes.** If the correction values are acceptable.
If **No**, perform these steps again.
9
Tap **Ok**.
10
Tap **Accept** to confirm the Plum Pole Routine is complete.
